Error Conditions - Christie GraphXMASTER RPMS-D100U User Manual

OPERATION
3.13 Error
Conditions
User Errors
Input Signal Errors
RPMS, CS50 & CS70-D100U/UF User's Manual
3-54
the screen) enough. In the White Uniformity menu Overall should be set to
50.0 or less. Do not exceed 50.0 – a higher level will interfere with achieving
brightness uniformity and is not recommended.
◊
Adjust corner White Uniformity last – each corner adjustment affects only
this quadrant.
◊
Repeat for each screen.
Canceling Brightness Uniformity
If you don not want to use or apply Brightness Uniformity settings, delete the
checkmark from the Uniformity Enable checkbox at the top of the Brightness
Uniformity menu.
Occasionally the projector may encounter an error condition that interrupts normal
operation. These can be caused by invalid user entry, an input signal error (most
common) or some other system error.
If you would like to be notified on-screen of such errors, select the Screen option
from the Display Error Messages pull-down list (in Menu Preferences menu). If you
would like to be notified via a serial communication only, select the RS-232 option
instead. To receive both notifications, select All. To disable error messages (except
for invalid user entries), select Off.
'
Invalid User Entry
Any keypad entry not recognized by the projector will trigger an on-screen error
message describing the problem. For example, if you specify a channel number that
has not been defined, the message "Invalid Channel" will appear. Or if you try to
enter the wrong password, you'll see "Invalid Password". Press
confirm the message and eliminate the message box.
NOTE: Displaying of "Invalid User Entry" messages cannot be disabled, even if
Display Error Messages has been set to Off.
'
Input signal errors messages appear when you are in presentation level (i.e., when
there are no menus present) and have selected an input on which the projector detects
a problem. While menus remain operational and pressing any key will temporarily
remove the message from the screen, you must resolve the signal problem in order to
permanently eliminate the message.
NOTE: Input signal messages appear on-screen only if Display Error Messages has
been set to Screen or All.
Exit
Enter
or to