Christie GraphXMASTER RPMS-D100U User Manual page 22

functions are disabled. To leave standby press and hold
OFF
Menu
Menu
Press
specific functions, such as Configuration or Image Settings. Press
remove all menus and return to presentation level.
Enter
Enter
Press
unchecked), or to accept a parameter adjustment and return to the previous menu or
image.
Exit
Exit
Press
NOTE:
editing of a slidebars) or within pull-down lists. It acts as a "cancel" in these cases.
ON OFF
, , ,
Arrow Keys
The arrow keys have a variety of functions depending on the situation. Some typical
uses are described below. See also Editing Text later in this section.
• Use
adjustment (note the adjustment increments and range depend on the parameter
being adjusted).
• Use
having to display the list first
• Use
lists.
Use the
increase or decrease the value in the second (bottom) slidebar of a double slidebar.
You can also use
including an asterisk symbol—to ensure a toggle only in the desired direction. If you
press
on, the projector will actually turn off if the projector was already on. Instead, to
avoid the risk of toggling in the wrong direction, quickly press and release normally
the function key you wish to toggle (in this case
seconds) press either
Toggle keys are labeled with an asterisk on the keypad. They are listed below:
Exit
). Or simply press or
Menu
to display the Main menu. A list of several options appears for access to
Enter
to select a highlighted item, to toggle a checkbox (checked vs.
Exit
to return to the previous level, such as the previous menu.
Exit
does not save changes within text editing boxes (including number
or to change a slidebar value—hold as desired for continuous
or to change to a different option within a pull-down list without
or to jump between "pages", such as in Help or lengthy pull-down
ON
OFF
or keys to navigate within a menu, pull-down list or text box, or to
ON OFF
or
*
Power
and hold it for approximately 1 second in hopes of turning the projector
ON
or
•
*
Stby ON
+ = put the projector in standby mode
*
Stby OFF
+ = leave standby
•
*
Power ON
+ = turn the projector on
*
Power OFF
+ = turn the projector off
•
*
Display Display
ON
+ = turn the menu system on
*
Display Display
OFF
+ = turn the menu system off
Menu
.
in conjunction with certain toggle keys—i.e., those
*
Power
OFF
as desired. The specific toggle will occur.
RPMS, CS50 & CS70-D100U/UF User's Manual
OPERATION
*
Stby Stby
again (or use
Menu
again to
). Then immediately (within 2
*
3-5