Christie GraphXMASTER RPMS-D100U User Manual page 80

Replacing a Lamp
TURN PROJECTOR OFF
1)
that you power down the projector prior to replacing a lamp. Press
power down the projector. The projector fans will continue to operate for a short
cool-down period. It is recommended that you wait approximately 5 minutes to
allow lamps to cool before replacing.
It is strongly recommended that you allow the lamp to cool before
HOT-SWAP ALTERNATIVE
Please read About the Lamp Hot-Swap Feature on the previous page before
proceeding.
If you choose to replace a lamp without disrupting the current presentation, it is
recommended that you switch to the Single Lamp mode for the lamp you are not
going to replace. Then proceed with Step 2. NOTE: The projector will not
automatically return to its original Lamp Mode after lamp replacement. This
must be done manually, if desired.
OPEN LAMP COMPARTMENT
2)
to open. Swing the door open. (Figure 4.2.) NOTE: Each lamp door is spring-
loaded and needs to be held open during lamp replacement.
For CS50/CS70: Remove the rear access
panel, mounted to the back of the display
cube, to access the projector's lamp
module.
MAINTENANCE AND TROUBLESHOOTING
: If your presentation allows, it is strongly recommended
WARNING
replacing – approximately 5 minutes.
: Loosen the two screws on the lamp door you want
Figure 4.2.
RPMS, CS50 & CS70-D100U/UF User's Manual
*
Power
to
4-7