Christie GraphXMASTER RPMS-D100U User Manual page 14

SOURCE SETUP
effective until the keypad is unplugged and plugged in again (if a wired remote) or
until a battery is removed (if an IR remote).
Figure 2.16. Independent Keypads and Projectors
'
Remote Keypad The standard IR remote keypad or the optional wired remote can be set to one of two
Protocol
different protocols — "A" or "B". To hard-wire a protocol to "A" or "B" in either
IR or optional Wired Keypad
remote, follow Steps 1 through 5:
Step 1
Unplug the keypad from the projector (applies to wired remote only).
Step 2
Unlatch and open the empty battery compartment on the back of the keypad as shown
in Figure 2.17.
NOTE: A wired keypad opens as shown, but a cable passes through the battery
compartment cover.
Figure 2.17. Opening the Keypad
Step 3
Find the 4 jumpers located along the latching side of the battery compartment. These
jumpers set the keypad protocol and other settings so that the keypad functions in a
certain manner.
2-11
RPMS, CS50 & CS70-D100U/UF User's Manual