Christie GraphXMASTER RPMS-D100U User Manual page 6

DVI Digital Video Signals
Figure 2.3. Connecting Component Video Sources
'
The DVI Input module installed in
conforming to the DVI (Digital Visual Interface) standard. This is a standard module
in D100U projector models only.
DVI Connection for D100U models
To connect an incoming digital video signal to the projector, connect the cable
running from the source to the DVI input connector at Input 2 - the DVI output
adjacent to the DVI input connector remains empty. If you want to loop the source
through to another display device, connect a cable from the DVI output connector
(that was empty) to a DVI input connector on the digital display.
Figure 2.4. Connecting a Digital Video Input Signal
2 displays digital video input signals
INPUT
RPMS, CS50 & CS70-D100U/UF User's Manual
SOURCE SETUP
2-3