Christie GraphXMASTER RPMS-D100U User Manual page 82

INSERT NEW LAMP
: a) Hold the new replacement lamp above the lamp
4)
compartment. Align the two holes on the lamp module with the locating pins
located on the edge of the lamp compartment. See Figure 4.5.
b) Slide the lamp all the way down until it is fully seated into the compartment.
See Figure 4.6.
Figure 4.6. Inside the Lamp Compartment
c) Tighten the two screws on the lamp module just until snug to hold it in place.
Do not over-tighten lamp screws – it could potentially
damage the lamp module. Tighten only until snug.
CLOSE LAMP DOOR
: Once the lamp is inserted, carefully close the spring-loaded
5)
lamp door and lock it by tightening the two lamp door screws.
Watch your fingers! The lamp door is spring-
loaded and will snap close. Keep fingers clear from
the lamp compartment opening when closing the
TURN THE PROJECTOR ON (IF APPLICABLE) OR SWITCH BACK TO THE
6)
ORIGINAL LAMP OPERATION MODE
MAINTENANCE AND TROUBLESHOOTING
Figure 4.5
WARNING
lamp door.
*
Power
: Press to turn the projector on. If you
RPMS, CS50 & CS70-D100U/UF User's Manual
4-9