Adjusting An Image - Christie GraphXMASTER RPMS-D100U User Manual

OPERATION
3.6 Adjusting an
Image
Size and Position
RPMS, CS50 & CS70-D100U/UF User's Manual
3-18
Most options for image adjustments can be accessed through two menus: Size and
Menu 1
Position ( ) and Image Settings (
menu. While in either of these two menus, you can change settings affecting the
image from the current channel by working with the appropriate slidebars,
checkboxes and pull-down lists. Selecting
menu (or to the presentation, if from the Main menu) and accept any changes you
may have made.
From your presentation, you can access any of the individual options in these menus
Menu
by pressing followed by the appropriate two-digit number representing their
location in the menu system. For example, press
Color Setup option in the Image Settings menu.
Note that for certain options, you may prefer to use a "direct key" from presentation
level to go directly to a particular option rather than traveling through the menu
system (Note: this is not available for all display parameters). For example, press
Cont
to access the Contrast slidebar immediately. Press
presentation.
NOTE: 1) To hide the "direct" slidebars only, make sure the Display Slidebars
option in the Menu Preferences menu is unchecked. 2) Press and hold the
to toggle the on-screen display OFF – this hides the entire menu system from view.
'
The Size and Position menu allows you to increase or decrease the size of your
image, change its proportion (aspect ratio), move the image to a specific area of the
screen, and refine other related parameters. Use Size and Position controls to match
the image precisely to the screen size and aspect ratio needed for your application.
Refer to Using Slidebars and Other Controls earlier in this section if you need help
using any of the following slidebars or pull-down lists to alter your image. Changes
made to the Size and Position menu are applied immediately and are saved when you
exit the menu (press
NOTE: Resize Presets, Size, Vertical Stretch, Lens Control, Keystone, Plug &
Display and Tiling Setup are not applicable to D100UF models. These projectors
display images in their native resolution only – they have no resizing ability.
Menu 2
Exit
Figure 3.10. Size and Position Menu
Exit
Menu
or ).
), both of which are listed in the Main
will always return you to the previous
2 6
Menu
to quickly access the
Exit
to return to your
*
OSD
key