Christie GraphXMASTER RPMS-D100U User Manual page 87

MAINTENANCE & TROUBLESHOOTING
Symptom
CAUSE / REMEDY:
Symptom
CAUSE / REMEDY:
Symptom
CAUSE / REMEDY:
RPMS, CS50 & CS70-D100U/UF User's Manual
4-14
'
There is noticeable flicker effects in the display...
1. Try turning the Lamp Conditioning option (Lamp menu) ON. If the entire
image is showing signs of flicker, it may be due to the inherent characteristic of
the UHP lamps. Turning Lamp Conditioning ON should gradually reduce this
effect.
2. Are you using an external signal with low frame rates (<48Hz)? Turn Lamp
Conditioning OFF to improve.
'
In a multiple display wall, the display of one projector set at 100W is
brighter than that of an adjacent display with the projector set at 120W...
1. Check the lamp hours of the projector displaying the dimmer image. Does the
lamp need to be replaced?
2. During primary color adjustment, try turning down the green white level of the
brighter projector until both projectors match in overall brightness. Then
continue with other adjustments as usual.
'
Can't seem to match whites between multiple displays....
1. It is strongly recommended that you use an internal 100% white field test pattern
when trying to adjust primary colors.
2. Turn White Boost OFF (move slidebar to a value of 0) when using an internal
100% white field test pattern to adjust primary colors.
3. Set all projectors in a multiple display to the same power level and lamp
operation mode before adjusting primary colors and/or input levels.