Christie GraphXMASTER RPMS-D100U User Manual page 7

SOURCE SETUP
Composite Video
2-4
RPMS, CS50 & CS70-D100U/UF User's Manual
NOTE: The DVI output connector (J94) on the output panel is used to connect the
Projection Head Module (PHM) and Electronics Module (EM).
DVI Loop Through for D100U models
To loop a single incoming digital video input signal (connected to the DVI input)
through to another projector connect a cable from the source to the DVI input
connector on the main input panel. Take another cable and connect it to the DVI
output connector (adjacent to DVI input) and connect it to the DVI input connector of
the next projector. Continue looping connection to all projectors – your last projector
will have an empty DVI output connector.
NOTES: 1) When looping a DVI input signal, all projectors will display the same
data from that one source.
DVI Connection for D100UF models
The DVI input connector available in D100UF models accepts DVI standard input
signals in the projector's native resolution only. No loop-through or resizing ability
available on these projectors.
Typical connection to this port is shown in Figure 2.6.
Figure 2.6. Connecting a Digital Video Input Signal to RPMS-500Xef
'
Connect a composite video input to either the BNC connector or the RCA jack
provided on the video decoder module (
NOTE: 1) Requires Optional Video Decoder (38-804600-01). 2) If you want to loop a
composite signal through to another projector or display device, see Video Loop
Through later in this section. 2) Not applicable to D100UF.
Figure 2.5. Loop Digital Video Input Signals
INPUT 3
).