Christie GraphXMASTER RPMS-D100U User Manual page 24

Func
Function Key
From presentation level, press
color or colors in the display. For example,
Func 6 7
data,
shown below and also appears on the back of the IR remote keypad. Color enabling
can also be accessed through the menu system rather than these shortcuts.
Func
NOTE: Once
non-numeric entry until 2 digits have been entered or until 5 seconds of inactivity
have elapsed.
Func
Use of the
elsewhere in Section 3. For example, press
deletion or copying of a channel.
*
OSD
OSD* (On-screen display)
Press and hold
visible or invisible). Or press
the correct toggle direction (useful if you are unsure of the present status). Note that
invisible menus are fully functional.
NOTES: 1) With OSD on, you can still mute menus, error messages, slidebars, etc.
with the appropriate setting in the Preferences menu.
Help
Help
Help
Press for detailed information about any current menu and highlight. Press
again to exit. From presentation level, press
consisting of Using Help, Setup, Keys, Source (Input) Selection, and Stat/Pwr LEDs.
Exit
Press to leave General Help and return to presentation level.
Test
Test
Test
Press to display one of the available test patterns. Press
next available pattern in the sequence.
Exit
at any time to remove the current test pattern from the screen and return to
presentation level.
NOTE: For a complete list of all test patterns, see the Geometry menu description
later in Section 3.
*
Display Display
Display *
*
Display Display
Use to hide the current menu. Press and hold
second to toggle on or off with a single key press. Or quickly press and release
Func
followed by a 2-digit number to enable a specific
will display all colors data. The list of available color combinations is
Func 6 1
= Red
Func 6 2
= Green
Func 6 3
= Blue
Func 6 4
= Red and Green
6 5
Func
= Green and Blue
Func 6 6
= Red and Blue
6 7
Func
= All colors (
is pressed in presentation level, the projector will not respond to
key within the menu system is noted with the appropriate topic
*
OSD
for approximately 1 second to toggle menus on or off (i.e.,
*
OSD
followed immediately by
RPMS, CS50 & CS70-D100U/UF User's Manual
Func 6 4
will display only red and green
Exit
does the same thing)
Func
in the Channel Setup menu to enable
ON
Help
to access the General Help menu
Test
Test
will exit after the last pattern, or press
*
Display Display
for approximately 1
OPERATION
OFF
or to guarantee
Help
again to display the
3-7