Christie GraphXMASTER RPMS-D100U User Manual page 10

Extra Video
– COMPOSITE OR S-VIDEO
Optional Inputs
Connecting a switcher
'
If you want to use an extra video source in addition to the video source(s) connected at
INPUT 3 INPUT 4
or connect either a Composite or S-Video source to
Do not connect both types here simultaneously. NOTE: For additional video inputs remove
the DVI Input module and install an optional Composite/S-Video Input Module at
'
Christie offers optional modules that allow you accommodate different signal types,
whether analog or digital. Any one of these modules can be installed in D100U
models, in the area labeled
•
•
•
•
•
•
•
•
NOTES: 1) Connect analog HDTV signals directly to
module installed at
Christie projector models is not needed or recommended. 2) See Appendix E,
Optional Input Modules for a brief description of each interface.
'
You can use one or more external Marquee
switcher in order to significantly increase the number of sources you can select. If
you are using a Marquee
INPUT 1
and connect an RS-232 serial communication cable between the switcher and
the projector serial port labeled
communication link (permanently set at 9600 baud) enables you to access inputs
connected to the switcher in the same manner as those connected directly to the
projector. For most other third-party switchers, connect and access sources according
to the documentation provided with that switcher. Use high quality shielded cables.
NOTE: Make sure any Marquee
projector is set as "Switcher #1". If it is not, unplug the switcher and turn the
thumbwheel to "1" before plugging back in and connecting to the projector and/or
network.
Figure 2.11. Connecting Extra Video
INPUT 2
. They include:
RGB 500 Input Module (38-804606-xx)
RGB 400 Active Loop Thru Input Module (38-804607-xx)
RGB 400 Buffered Amplifier Input Module (38-804610-xx)
Composite/S-Video Input Module (38-804608-xx)
PC250 Analog Input Module (38-804609-xx)
Serial Digital Input Module (38-804602-xx)
Digital HDTV Input Module (38-804611-xx)
Video Decoder Module (38-804600-01)
—the optional HDTV Input Module used in earlier
INPUT 2


Signal Switcher, connect the switcher's RGB output to
SWITCHER

Signal Switcher connected directly to the
RPMS, CS50 & CS70-D100U/UF User's Manual
INPUT 1
or to any "RGB" input
INPUT 1
Signal Switchers or a third party
(see Figure 2.12). The switcher
SOURCE SETUP
as shown in.
.
INPUT 2
2-7