Error Conditions - Christie roadie 25k User Manual

OPERATION
Focus
Anamorphic Lens
3.14 Error
Conditions
User Errors
3-66
Roadie 25K User's Manual
'
For overall focus
improvement, rotate
the focus adjustment
knob directly under
the lens. For best
results, use a
crosshatch test
pattern or similar,
and focus on the
center of the image.
If the focus quality
differs from edge-to-
edge (whether top, bottom, left or right), the boresight of the lens mount likely needs
correction (see Section 2, Installation and Setup).
'
NOTES: 1) The anamorphic lens and its mounting structure are optional
components. 2) To install, replace or use the anamorphic lens, refer to the
instructions included with the anamorphic lens mount kit.
To widen a "squeezed" image into a scope (2.39:1) theatre display, swing the 1.25x
anamorphic lens into place in front of the primary zoom lens of the projector. This
lens increases magnification across the width only, regaining the original proportions
in the image, and is often used with screens where side masking can be moved aside.
Occasionally the projector will encounter an error condition that can interrupt normal
operation. Such a condition can be caused by a simple invalid keypad entry, an input
signal error (most common) or a system error. The manner in which users are to be
notified of error conditions is set in the Menu Preferences menu:
• To see error messages displayed on-screen, select the "
• To be notified via a serial communication only, select the "
• To receive both types of notifications, select "
• To disable error messages (except for "invalid user key entry", which can't
be hidden), select "
Note that text-based status/error messages also appear in the LCD Status Display
window above the keypad at the rear of the projector. They are accompanied by their
corresponding 2-digit error code next to the
keypad, legible at a greater distance. Normal
operation is indicated by the "00"status code.
Invalid User Entry
'
A keypad entry not recognized by the projector triggers a short on-screen error
message identifying the problem. For example, if you specify a channel number that
is not available, the message "Invalid Channel will appear. Or if you try to enter the
wrong password, you'll see "Invalid Password". Press
message and try again.
NOTE: On-screen display of "Invalid User Entry" messages cannot be disabled,
even if Display Error Messages has been set to "Off".
Off
".
Screen
" option
RS232
" option.
All
".
Enter or Exit to clear the