Christie GraphXMASTER RPMS-D100U User Manual page 75

MAINTENANCE & TROUBLESHOOTING
Lamp
Power Cord
and Attachments
Ventilation
RPMS, CS50 & CS70-D100U/UF User's Manual
4-2
◊
Do not place the projector on an unstable cart, stand or table. A projector and cart
combination should be used with care. Sudden stops, excessive force and uneven
surfaces may cause the projector and cart combination to overturn.
'
The two identical 100W UHP lamps should be replaced when they have reached their
end of life, or have failed during operation. To effectively maintain operation of your
projector it is best to be aware of any changes that occur in brightness and the
number of hours each lamp is in use.
Follow all safety and warning precautions regarding lamp replacement and handling.
It is recommended that you either turn off the projector
before replacing a lamp or at least cutting power to the
lamp you are about to remove when performing a hot-
swap. If you turn the power off, wait approximately 5
minutes to allow the lamp to cool before removing.
To prevent physical injury, do not stick hands into the
The lamp is under great pressure when hot and may
explode causing physical injury and/or property
damage. Allow a lamp to cool before handling and/or
powering down and unplugging the projector.
Use only the lamps specified and supplied by CHRISTIE
'
Use only the attachments and/or accessories recommended by CHRISTIE. Use of
others may result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied by the
manufacturer. Do not attempt operation if the AC supply
is not within the specified voltage and power range.
◊
Do not set or rest items on the power cord. Locate the projector in an area where
the projector cord cannot be abused or damaged by persons walking on it or by
objects rolling over it.
◊
Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
◊
The projector is equipped with a three-wire plug having a third grounding pin.
This is a safety feature – if you are unable to insert the plug into an outlet contact
an electrician to have the outlet replaced. Do not defeat the safety purpose of this
grounding-type plug. NOTE: The power cord supplied with the projector is
approved for North American use only. An appropriately rated power cord with
IEC320 type plug is required for European and other countries.
'
Slots and vents in the projector provide ventilation. Never block or cover these
openings. This ensures reliable operation of the projector and prevents overheating.
LAMP WARNINGS
lamp module during lamp replacement.
in the Lamp Replacement Kit.