Christie GraphXMASTER RPMS-D100U User Manual page 15

SOURCE SETUP
2-12
RPMS, CS50 & CS70-D100U/UF User's Manual
Step 4: Set the Jumpers
Set the jumpers as shown in Figure 2.18. Refer to the correct part of the drawing —
IR or wired (optional). Use tweezers or needle-nose pliers to remove and replace
each jumper as necessary.
•
J1 jumper: For either remote, set between pins 1 and 2 to set as Protocol "A".
Set between pins 2 and 3 to set as Protocol "B".
•
J2 jumper: For either remote, set between pins 2 and 3 as shown; otherwise, the
projector will not respond correctly to keypad commands.
•
J3 jumper: For the IR remote, make sure that the jumper is set between pins 2
and 3 as shown. For the wired remote, make sure that the jumper is set between
pins 1 and 2 as shown.
•
J4 jumper: For the IR remote, make sure that the jumper is set between pins 1
and 2 as shown. For the wired remote, make sure that the jumper is set between
pins 2 and 3 as shown.
Step 5
Replace battery compartment cover. Plug into projector (wired keypad only) and test.
Figure 2.18. Locating and setting keypad jumpers
NOTE: A wired keypad can be converted into an IR remote keypad, and vice versa.
Follow the settings shown above, adding or deleting the cable and batteries as
required. The cable is available separately from your dealer – #38-804011-01)