Christie GraphXMASTER RPMS-D100U User Manual page 64

OPERATION
Figure 3.30.
LAMP HOURS
– This read-only information indicates the number of hours logged on
the current lamp. Whenever you record a new lamp serial number, this value
automatically resets to "0", where it begins to log time for the new lamp. NOTE: You
can also check Lamp Hours in the Status menu.
LAMP S/N
– This read-only information displays the serial number recorded for the
current lamp. When you install a new lamp and enter its serial number (9-digits), the
number will appear here in the Lamp menu.
LAMP 1 (OR 2) STATUS
– This read-only information displays the current status of the
lamp (1 or 2). An extremely valuable piece of information for troubleshooting, the
Lamp Status can be any one of the six following states: "Good", "Cooling Fan #3
Failed", "Cooling Fan #5 Failed, "Interlock Tripped", "Failed to Strike" and
"Turned Off Unexpectedly". You can view the status of a lamp anytime during
operation by accessing its submenu.
LAMP 1 (OR 2) HISTORY -
Select this numbered item to access a
smaller dialog box with read-only information about the history
previous lamps installed and recorded. The serial number and
number of hours logged for each lamp is displayed. The Lamp
History is automatically updated whenever the serial number for a
new lamp is recorded. The information for the new lamp is added to the bottom of the
list.
NOTE: If you remove lamps from the projector it is important to replace them back
into the compartment from which they were removed. This ensures accurate lamp
information is maintained. Each lamp compartment is labeled Lamp 1 and Lamp 2.
CHANGE LAMP
– Select this option to record a serial
number of up to 9 digits/characters for every newly
installed lamp. When selected, a Lamp S/N window
appears. Use the number text entry keys to record the new
Enter
lamp serial number and press again to accept the change. See Using Slidebars
and Other Controls if you need help entering the number. Once entered, the new
lamp serial number will be added to the Lamp History menu and the Lamp Hours
timer will reset to "0". Lamp Mode and Lamp Limit remain as they were for the
previous lamp, and can be changed at any time.
NOTE:1) Enter a serial number only if you have just installed a new lamp. This will
help ensure the lamp timer is not reset on an old lamp and that the number of hours
logged on the lamp will be accurate. 2) Lamp serial number can be found on the
lamp itself.
RPMS, CS50 & CS70-D100U/UF User's Manual
3-47