Components; Purchase Record And Servicing - Christie GraphXMASTER RPMS-D100U User Manual

INTRODUCTION
How the projector works
in Single or Dual Lamp
Modes
1.2

Components

1.3 Purchase
Record and
Servicing
RPMS, CS50 & CS70-D100U/UF User's Manual
1-2
'
The projector accepts an SXGA input signal from an external source. When in Dual
Lamp operation mode, the output from both lamps is directed to a 90° prism. Due to
the placement of the prism, in relation to the lamps, only half of the lamps output is
reflected and the light that doesn't fall incident on the prism is passed on to the
parabolic reflectors inside each of the lamp modules. After one pass around the
system, the light joins the rest of the light that has been reflected off of the prism and
into the focusing lenses. The combined light is then passed through the integrator and
presented to a spinning color wheel where it is sequentially filtered into its RGB
color primaries and presented to the single DMD (in sequence). Reflected light
from the DMD chip then passes through the projection lens and is displayed on a
screen for viewing.
In Single Lamp operation mode, light is passed through the system in the same
manner, but only one lamp is on and light output is reduced by half.
NOTE: The RPMS and CS70 include a four-segment color wheel (red, green, blue
and white). The CS50 includes a six-segment color wheel without a white segment
(red, green, blue, red, green, blue).
Each projection system is provided with a User's Kit, which includes items required
in the setup and maintenance of the projector. Check the User's Kit to ensure you
have received the following items:
♦ User's Manual
♦ Installation Guide
♦ IR remote keypad with batteries
♦ Assorted ball nose drivers
NOTE: Additional User's Kits can be purchased separately. Reference CHRISTIE
#38-804867-01 for RPMS-D100U/UF and #38-804827-01 for CS50-D100U, CS70-
D100U/UF when ordering.
Whether the projector is under warranty or the warranty has expired, Christie's
highly trained and extensive factory and dealer service network is always available to
quickly diagnose and correct projector malfunctions. Service manuals and updates
are available to service technicians for all projectors.
If you encounter any problems with the projector and require assistance, contact your
dealer or Christie Digital Systems. Fill out the information in the table below and
keep with your records for future reference.
Dealer:
Dealer Phone Number:
Projector Serial Number:
Purchase Date:
Installation Date, if applicable:
NOTE: The projector serial number can be found below the adjustment mechanism on the mounting plate.
You can also register your product on-line by visiting www.christiedigital.com ⇒
Service and Support ⇒ Product Registration. This will keep you in touch with all
the latest product information, such as updates, technical bulletins, downloads and
Christie newsletters.
Purchase Record