Christie GraphXMASTER RPMS-D100U User Manual page 19

OPERATION
3-2
RPMS, CS50 & CS70-D100U/UF User's Manual
Electronics Module (EM)
The EM module contains the main electronics and input connectors of the projector.
Your projector model identifies which type of EM you have D100U or D100UF.
Main Input Panel
All source connections are made to the main input panel. NOTE: The
connectors located on the input panel vary between models. See Section 2.
Auxiliary Fan Connector
A connector exists on the side of the EM and can be used to connect a
separate cooling fan – useful in applications where the projector is mounted
within the confines of an enclosure and where airflow is required.
Refer to Appendix D for pinout information.
Status and Power LEDs
Two LEDs are located in the lower right corner of the main input panel,
which indicates projector "Status" (top) and "Power" (bottom). During
normal operation, the "Power" light is steady green and the "Status" light
flashes green each time a key is pressed on the keypad or the projector
receives a serial communication command.
6-Axis Adjuster
The projector provides the ability of modifying the geometry of a displayed image
using the uniquely designed 6-Axis adjustment mechanism. This mechanism is
shipped from the factory in a nominal position and can be adjusted using a 3/16" ball
driver. All adjustments made to the adjuster can be "locked" into place by tightening
the lock screws and setscrews. Instructions and tools required to adjust the 6-axis can
be found in the User's Kit.