Christie GraphXMASTER RPMS-D100U User Manual page 45

OPERATION
RPMS, CS50 & CS70-D100U/UF User's Manual
3-28
SELECT COLOR TEMP –
be changed here just as in the Color Setup menu. When a User color temperature is
selected, the White Level and Interpolated options are disabled and can be adjusted
to create your own color temperature.
INTERPOLATED COLOR –
Interpolated Color if you need a specific color temperature somewhere in between
two preset color temperatures. For example 7841 is interpolated from 6500 and 9300.
These 3 controls are adjustable only if a User choice is selected (in
WHITE LEVELS –
which case User 1, 2, 3 or 4 appears at the top of the Color Temperature Setup
menu). Their current values are shown for the active color temperature. Changing a
white level here changes the drive (contrast) for that color essentially creating a new
color temperature that is "warmer" or "cooler" etc. For maximum overall
brightness, always keep at least one white level at 100. When you are satisfied
with the new "User" temperature, it can be used immediately upon exit or it can be
selected from either the Color Setup menu or the Color Temperature Setup menu, as
usual. You can re-define a User color temperature at any time using the Color
Temperature Setup menu.
Select which color or colors you want to see, useful while working
COLOR ENABLE –
with color temperature white levels.
Use this option to replace the currently selected User color
COPY FROM –
temperature setup with that of another. This function can be particularly useful for
creating a starting point for a new User color or for accessing an unaltered factory
default. It is disabled for all color temperatures except User. See Figure 3.14.
How do you copy a Color Temperature?
To create a starting point: To set a starting point for a new custom user color
temperature, select a user temperature, then highlight Copy From and select a
The current color temperature is shown in the menu and can
Use this option to increase or decrease the value of
Figure 3.14. "Copy From"