Christie GraphXMASTER RPMS-D100U User Manual page 16

Converting a Keypad
'
If desired, you can convert an IR remote keypad into a wired remote keypad and vice
versa.
TO CHANGE FROM INFRARED TO WIRED:
1. Remove battery compartment cover from back of keypad.
2. Remove batteries.
3. Wait 1-2 minutes.
4. Set keypad protocol as desired, using "wired" jumper settings.
5. Plug the keypad cable (available separately) into the empty battery
compartment. Make sure that the battery cover is notched smoothly to
accommodate the cable.
6. Replace battery compartment cover.
7. Plug into the 3-pin XLR port at the rear panel of the projector.
TO CHANGE FROM WIRED TO INFRARED:
1. Unplug the keypad from the projector.
2. Open the keypad cover and unplug the keypad cable.
3. Wait 1-2 minutes.
4. Set keypad protocol as desired, using "IR" jumper settings.
5. Install batteries (see Section 4).
6. Replace battery compartment cover.
RPMS, CS50 & CS70-D100U/UF User's Manual
SOURCE SETUP
2-13