Table of Contents
Advertisement
66
19.2.5 TX Signal Settings
TX OUT menu
Fig. 97
Pushing TX-OUT softkey (TX menu) will call up TX OUT menu:
Return to TX menu (see Page 62)
TX signal will be routed to internal power amplifier; the display will show the
10 Watt or 250 Watt Scale OUTPUT POWER (see Page 69);
the softkey will be displayed inverse (shown).
Additional delay of the RF signal in relation to the PTT signal
between 0 ms and 50 ms with 5 ms steps; pushing Delay (the
softkey will be displayed inverse)and turn STEP-VFO knob; input
modus deactivated after 5 seconds inactivity (TX EXT only).
Activation "Wait for External Device": The PT-8000A sends out
no RF signal unless an enable signal (e.g. from an external PA) is present at
J17 pin 9.
TX signal will be routed to socket TX ext. +20dBm (J14; BNC; rear panel), to
drive external equipment (power amplifier, transverter). The internal power
amplifier will be shut down; the softkey will be displayed inverse; the display
will show the 100mW Scale OUTPUT POWER (see Page 69).
Advertisement
Table of Contents
