Table of Contents
Advertisement
PT-8000A Operating Manual v2.00.33
5.3
Operating and Display Elements at Front Panel
ON/OFF for DC Low Power
13.8 V (J4) PT-8000A RX and
DC AUX 13.8 V (J2) rear panel
6
A
CCESSORIES
6.1
Base Station Microphone Dynamic T9
Fig. 7
6.2
Wiring / Cables
Fig. 8
ON/Off for DC Output
50 V (J4) PT-8000A
TX-Power Amplifier
Fig. 6
Make sure before connecting to mains to turn OFF (press down) both
switches (LINE and PA).
Best suited for all voice operations is the Hilberling Dynamic T9 especially
designed for the PT-8000A.
Isolated from any mechanical vibrations and designed to be used from more
closer as well as from greater distance it will always guarantee high fidelity
audio and if desired an extra punch to the signal.
It is equipped with a microphone preamp.
Impedance is 600 Ω @ 1 kHz. The acoustic characteristic is kidney-shaped.
Finish: Black anodized
AC line voltage cable (power grid ⬄ HN-8000) length approx. 1.7 m
Automatic Fuse for DC-
Output 13.8 V / 5 A (J2)
AUX rear panel
The power meter indicates the
DC input power of the final
power amplifier – hence
computation of efficiency could
be easily done by comparing
RF-power out as indicated on
PT-8000 display and DC-input
shown here.
9
Power Meter
PA DC-Input
Advertisement
Table of Contents
