Table of Contents
Advertisement
2
A2-
A2.4
Setup Software and Firmware
A2.5
Install Update Program on PC
A2.6
Connect PT-8000A to PC by USB Data Cable
The setup software is delivered with the PT-8000A transceiver on CD-ROM. It
will install the Hilberling update program on your PC.
Load the CD-ROM into the CD/DVD/BD drive.
Say on your PC this drive is allocated to the character D: the setup file can be
found in the following directory:
D:\Software\
Alternatively, the setup file first can be copied to the Windows desktop or into
any other directory on the PCs hard disk drive, e.g.:
C:\Downloads\
Do the same with the new PT-8000A firmware. If you get it on CD-ROM it is
located in the directory
D:\Firmware\
If the firmware exists as a compressed archive file (ZIP file) it must be
unpacked before further use.
To start the installation double-click the file
setup_PT8000_Update.exe.
On CD-ROM it can be found in the directory \Software\.
If the file was first copied to the Windows desktop or to another directory on
the hard disk, e. g. to C:\Downloads\, double-click it there.
The update program will be installed by default into the standard
directory depending on current Windows version.
A program linkage (PT8000_Update) will be added by default to the
Windows start menu folder Start Programs PT8000_Update.
Optional a program linkage can be created on the Windows desktop.
For software update (see the following chapter A2.7) connect the PC (any USB
connector; Type A) and the PT-8000A (connector J22, Type B, see Operating
Manual Page 5) using the included USB data cable.
Advertisement
Table of Contents
