40
11.6 VFO Management
Fig. 49
Fig. 50
Both receivers (MAIN- and SUB-RX) have its own two VFOs –
VFO A and VFO B. Switching between VFO A and VFO B is
established through VFO A/B pushbutton. The button is located in
the cluster VFO.
In addition to frequencies the VFOs store filter
bandwidth and operation mode.
When pushing VFO A/B:
In case the VFO softkey menu is already displayed the active RX will
change its VFO (A⇨B or B⇨A).
If a different softkey menu is displayed the first push will call up the VFO
menu. The second push will alter the VFO A and VFO B.
Both frequencies displayed for the active RX will alter its
position. The white display always shows the selected
VFO. The VFO can be identified through the red
nominators A respectively B.
The smaller green display always shows the alternate VFO
that is in standby mode.
Only the SUB-RXs selected VFO frequency is displayed without its identifier A or
B.
active RX
(shown: MAIN-RX)
selected VFO (shown: A)
RX in the background
(shown: SUB-RX)
selected VFO (A or B)
Fig. 51