Table of Contents
Advertisement
12
A2-
Abb.
38
A2-
Comparing Version
Numbers
Fig.
39
A2-
Fig.
40
A2-
Warning Notices
Fig.
41
A2-
Does the new operation program loaded in the PC not match to the selected
CPU of the PT-8000A, this is pointed out with an error message box (Fig.
38).
Note that the selected CPU of the PT-8000A matches to the operation
program loaded in the PCs update program (letters M, R and K are prefixed to
the version number).
Now the update program compares the version numbers of the current and
the new operation program. Depending on the outcome different messages
are shown on the PT-8000A display and PC message boxes.
In case the new operation program has a higher version number than the
current version on PT-8000A, the display will show these numbers in lower
area.
Pushing ESC leads back to the screen and the softkey menu
Softwareversion (Fig.
(Prompt see Fig.
Display of current and new program version.
On the PC, a message box prompts you to start the program transfer.
Click OK to start the program transfer.
In case the new operation program has the same version number as the
current version on PT-8000A, the display will show a warning notice and in
the lower area these (identical) numbers.
Pushing ESC leads back to the screen and the softkey menu
Softwareversion (Fig.
Warning notice: The new program version is identical to the
current one!
Prompt to confirm the program transfer on the PC.
Display of current and new program version.
16/17).
A2-
35).
A2-
16/17).
A2-
A2-
Advertisement
Table of Contents
