Table of Contents
Advertisement
PT-8000A Operating Manual v2.00.33
Example
VFO menu
Fig. 52
Example
VFO menu
Fig. 53
In case the MAIN-RX is the active RX and its VFO A is the selected VFO, the
VFO menu is displayed as follows:
active RX: MAIN-RX with selected VFO A
The frequency of the selected VFO (shown: A) from the active RX (shown:
MAIN-RX) will be copied to the selected VFO (without identifier) from the RX in
the background (shown: SUB-RX).
The frequency of the selected VFO (without identifier) from the RX in the
background (shown: SUB-RX) will be copied to the selected VFO (shown: A)
from the active RX (shown: MAIN-RX).
The frequency of the selected VFO (shown: A) from the active RX (shown:
MAIN-RX) will be copied to the VFO in standby (shown: B) from the active RX
(shown: MAIN-RX).
VFO SPLIT: The Frequency of the selected VFO (shown VFO A) from the active
MAIN-RX will be used for RX; the selected VFO (without identifier) from the
SUB-RX in the background will determine the TX frequency (see also P. 42); to
the left of the Display
SPLIT
inverse.
Softkey STEP
(towards fine tuning) decreases the tuning increments by
power of 10. Additional digits appear at the VFO frequency readout.
Softkey STEP
(towards coarse tuning) increases the tuning increments by
power of 10. Lesser digits appear at the VFO frequency readout.
SPLIT operation using VFO A and VFO B (= VFO SPLIT) is only possible with
the MAIN-RX (the active RX. SUB-RX is in the background).
In case the SUB-RX is the active RX and its VFO B is the selected VFO, the VFO
menu is displayed as follows:
active RX: SUB-RX with selected VFO B
The frequency of the selected VFO (shown: B) from the active RX (shown: SUB-
RX) will be copied to the selected VFO (without identifier) from the RX in the
background (shown: MAIN-RX).
The frequency of the selected VFO (without identifier) from the RX in the
background (shown: MAIN-RX) will be copied to the selected VFO (shown: B)
from the active RX (shown: SUB-RX).
The frequency of the selected VFO (shown: B) from the active RX (shown: SUB-
RX) will be copied to the VFO in standby (shown: A) from the active RX (shown:
SUB-RX).
VFO SPLIT is not applicable if SUB-RX is the active one; for SPLIT operation the
MAIN-RX must be active, see above.
Softkey STEP
(towards fine tuning) decreases the tuning increments by
power of 10. Additional digits appear at the VFO frequency readout.
Softkey STEP
(towards coarse tuning) increases the tuning increments by
power of 10. Lesser digits appear at the VFO frequency readout.
will be displayed; the softkey will be displayed
41
Advertisement
Table of Contents
