Installation / Initial Operation; Introduction; Cable Connectors; Initial Settings - Hilberling PT-8000A Operating Manual

PT-8000A Operating Manual v2.00.33
7 I
NSTALLATION
7.1

Introduction

7.2

Cable Connectors

7.3

Initial Settings

Power On
/ I O
NITIAL PERATION
Prior to any operation of the PT-8000A read this Operation Manual carefully
notably before activating the transmitter.
The PT-8000A will be delivered with the following presettings:
 The preselectors of both RX are aligned and all data are stored in RX-
CPU memory which is buffered through a NiCd battery.

The transmitter is unlocked according to the band plans of that IARU
region (see Page 36) the PT-8000A is delivered.
The IARU region can be changed by software update.

Prior applying main power to the power supply HN-8000 please verify the
following points (7.2).
Please check at the rear panel of PT-8000A and HN-8000:

Antenna(s) is/are connected properly

Grounding stud is connected to station ground

Grounding wire is connected to both PT-8000A and HN-8000

DC cable is connected to both PT-8000A and HN-8000
For initial operation we recommend not to connect external amplifier,
transverter or devices for remote operation.
Please check at the front panel of HN-8000 (see Page 9):

Both switches (LINE und PA) are pushed down (off)
Please check at the front panel of PT-8000A (see Page 12):

Main switch (POWER) is pushed down (off)

Volume controls MAIN and SUB are set fully counter clockwise

TX-PWR knob is set fully counter clockwise

MIC-GAIN knob is set fully counter clockwise

PROC knob is set fully counter clockwise

Microphone T9 is connected

Connect power supply HN-8000 to main power

Turn on both LINE and PA on HN-8000

Turn on POWER at PT-8000A
It is up to the operator to switch PA off (switch PA at the HN-8000) during
reception only.
11