Table of Contents
Advertisement
56
17.4 NF Recording VOICE RECORDER
VOICE REC menu
Fig. 82a
Graphics Display
Recording
Playback
For audio signal recordings there are 4 memory tracks available with a
capacity of 29.8 seconds each track.
Pushing VOICE REC softkey (MENU menu) will call up the VOICE REC menu;
a graphic (Figure 82b) will be displayed right next to the frequency:
Return to MENU menu.
Cyclic change of record source when pushing repeatedly.
MAIN (-RX) SUB (-RX) MIC (-TX) 0dBm (-TX) DATA (-TX)
Start and Stop of recording (toggle mode); Start and Stop will be displayed
accordingly.
Play and Stop playing (toggle mode) of all takes of the current track; Play and
Stop will be displayed accordingly.
Clear recording memory (current track only).
Loop all recordings (current track only).
The selected memory track is shown as a blue number and a yellow
marker above the track graphic; select track by turning STEP-VFO knob.
Recording position and status is shown as R> [seconds] and a blue bar in
the graphic.
Play position is shown as P> [seconds] and a red marker line in the
graphic.
If one track is only partially written one or more recordings can be added.
In case the memory track has reached its capacity the recording will be
ceased. Rec Start will be displayed. However, a new record is not possible
until the memory has been cleared.
Playback will always start at the very beginning of the track.
When playback is finished (end of record or Stop) Play softkey is displayed.
The loop function may be activated during playback; the record will be
repeated endless until Stop is activated.
All Audio Signals (CW, SSTV etc.) can be recorded.
If the records are to be transmitted simply key the TX (transmit key T9; TX / ON-
Taste).
Fig. 82b
Advertisement
Table of Contents
