Repeater Mode - How To Set The Repeater Frequency Shift; Repeater Mode - Tx Frequency Display - Hilberling PT-8000A Operating Manual

PT-8000A Operating Manual v2.00.33
10.2.1 Repeater Mode – How to Set the Repeater Frequency Shift
10.2.2 Repeater Mode – TX Frequency Display
When pushing SET RPT softkey (FM menu):

SET RPT softkey will flash inverse.

VFO display will show the actual transmit frequency.

Band- respectively linear scale changes (range 0 ... 2.000)

Set VFO to desired transmit frequency hence define the shift within a
tuning range from 0 ... 2000 kHz.
The frequency resolution selected for the VFO will apply for this setting. It
can be modified by STEP-VFO softkey in the same menu.
 Alternatively use STEP-VFO knob to set the frequency shift.
Pushing SET RPT again will terminate the SET RPT mode.
The frequency shift is used both for RPT– and RPT+.
Switch to a different operating mode will terminate the setting as well.
Numerical frequency shift input is not possible.
Activation of PTT (pushing TX-ON button in the cluster ANT-TUNER
respectively TX pushbutton at Microphone T9) changes frequency display of
the selected VFO:
Now the TX frequency – decreased (FM-) or increased (FM+) by adjusted
frequency shift - is shown.
25