Rit / Xit Operation - Hilberling PT-8000A Operating Manual

PT-8000A Operating Manual v2.00.33

11.8 RIT / XIT Operation

Fig. 54
oder
RIT/XIT menu / RIT/XIT offset
RIT: Resulting RX Frequency when receiving
XIT: Resulting TX Frequency when transmitting
Fig. 56
RIT (Receiver Incremental Tuning) allows to shift/adjust the receiving frequency
plus/minus 9.999 kHz against the transmit frequency. The MAIN-RX and the
transmitter are no longer „transceive". RIT is only possible with the MAIN-RX.
XIT (Transmitter Incremental Tuning) allows to shift/adjust the transmitting
frequency plus/minus 9.999 kHz against the receiving frequency. The MAIN-RX
and the transmitter are no longer „transceive". RIT is only possible with the
MAIN-RX.
When pushing RIT/XIT button located in the cluster VFO:

RIT/XIT LED will be on.
 RIT/XIT menu will be called up. RIT or XIT will be displayed inverse (after
power-on RIT will be activated = power-on default).

CLAR knob will be activated (functions see below, Fig. 56).

RIT or XIT and the offset frequency will be displayed right next to the
frequency (after power-on RIT will be activated; the offset frequency will be
set to 0.000 kHz = power-on default).
In case of RIT is activated, the display will show the RX frequency affected by
offset frequency (= resulting frequency). When TX operation during XIT
activation, the display will show the TX frequency affected by offset frequency
(= resulting frequency).
 Turning the knob CLAR (clarifier) located right next to the cluster VFO will
adjust the offset frequency.
 Pushing the knob CLAR will toggle the offset frequency between selected
value and 0.000 kHz.
Activation RIT (as shown here)
Activation XIT
Reset the offset to zero
Fig. 55
Offset Frequency
RIT / XIT
43
Status
RIT or XIT