Scale Select Meter - Hilberling PT-8000A Operating Manual

PT-8000A Operating Manual v2.00.33
18 S S
C AL E E LE C T
Fig. 83
METER menu
Fig. 84
METER
The METER button located in the cluster DISPLAY will call up the METER menu
with following options:
1. Selection of meter display right below the S-Meter (Figure 85a/b):
 Control voltage of the Automatic Level Control (ALC)

MIC compression level (COMP)
2. Selection of scale units for input signal strength (Figure 86a/b/c):

Hams radio units (S + dB)
 Input power @ 50 Ohm (dBm)
 Input voltage @ 50 Ohm (dBµV).
When pushing METER:
 METER-LED will be on
 METER menu will be called up:
Control voltage of the ALC will be displayed (SSB
mode only);
the softkey will be displayed inverse (as shown here).
Compression level from MIC / TX will be
displayed;
the softkey will be displayed inverse.
S-Meter indicates S + dB;
softkey displayed inverse
(as shown here).
S-Meter indicates dBm;
softkey displayed inverse.
S-Meter indicates dBµV;
softkey displayed inverse.
*
* LED temporary disabled
57
Fig. 85a
Fig. 85b
Fig. 86a
Fig. 86b
Fig. 86c