Table of Contents
Advertisement
34
11.3 Channel Operation
11.3.1 Recall of Stored Frequencies CHANNEL
Fig. 40
CHANNEL menu
Fig. 41
Recalling of VFO adjustments (frequency, mode and filter bandwidth) is done
pushing the CHANNEL button located in the cluster MODE. It gives access to
3 banks of memory each storing 99 channels provided by PT-8000A.
When a memory channel is selected the stored adjustments are active with the
current RX immediately. They can be transferred to the VFO permanently
⇨
(CHAN
VFO) or can be restored with changed parameters as well
(overwriting) (SET MEM).
When pushing CHANNEL:
The last used channel will be activated and the RX operates with its
frequency and the other stored adjustments.
CHANNEL LED will be on.
CHANNEL menu will be called up (see below).
The frequency display of the standby VFO will be substituted by
information about the active channel (see Page 35 Figure 42).
When CHANNEL function is active toggling between MAIN-/SUB-RX and VFO-
A/B is inhibited.
Select bank #1; the softkey will be displayed inverse.
Select bank #2; the softkey will be displayed inverse.
Select bank #3; the softkey will be displayed inverse (as shown here).
Select (earmark) actual channel for SCAN modus **; this can also be done by
pushing the knob MEM/CH / STEP-VFO.
Writing channel to selected VFO from active RX. The CHANNEL mode will be
terminated and the VFO menu will be called up (see Page 35).
Writing current VFO adjustments to selected memory channel; if this channel
was selected for SCAN-modus the earmark will be deleted; it must be selected
again if required (see also Page 36 – MEM).
** Function temporary disabled
Advertisement
Table of Contents
