Table of Contents
Advertisement
PT-8000A Appendix A2 v2.00.33
A2.9
Update of MAIN-CPU
Fig.
18
A2-
Fig.
19
A2-
Error Messages
Fig.
20
A2-
Pushing MAIN Update softkey (SOFTWARE menu; Fig.
update process for the MAIN-CPU.
The display will show the boot loader screen with a prompt
to start the update program on the connected PC.
The PT-8000A is now ready to update, and the program transfer can begin.
Requirements for a successful program transfer are:
1. PT-8000A and PC are connected via USB cable (A2.6).
2. The update program has been started, a COM port is connected and
the new operation program (update file) is loaded (A2.7).
3. The PT-8000A is ready to update (A2.8).
4. The Update standby mode of the PT-8000A and the loaded operating
program agree respecting the CPU (MAIN-CPU).
Click the Start button in the main window of the update program.
The adjacent message box prompts you to set the PT-8000A
ready to update.
This is already done, so click OK (Otherwise please catch up
before clicking, see chapter A2.8).
If a connection error is occurred (e.g. PT-8000A is not ready to update), the
adjacent message box will be shown (Fig.
Check the correct connection of PT-8000A and PC (by the supplied USB data
cable).
If the update procedure should not be further
continued at this point, the PT-8000A is set back
to the normal mode by turning off (POWER) and
restart (after a wait of about 10 seconds).
20).
A2-
7
A2-
16/17) will start the
A2-
Advertisement
Table of Contents
