4
A1-
A1.6.3 Peak Hold
Fig.
6a
A1-
A1.6.4 Sample-Rate and Buffer Setup
Fig.
7
A1-
Marker is deactivated each time the program was started and can be activated
by clicking Marker (Fig.
When Marker is activated click into the relative display area (MAIN- (II) or
SUB-RX (III)) on a frequency shift (-line) of your choice.
The function Peak Hold stores the maximum value of each frequency in the
panorama over a period of three seconds and displays them as a green curve.
At the end of this period the curve will be deleted and the procedure starts
from the beginning.
Peak curve (green)
Current curve (yellow)
Peak hold is deactivated each time the program was started and can be
activated by clicking Peak hold (Fig.
When the program is new installed it is recommended to check the settings for
sample rate and buffer.
Click in the menu Tools the entry Settings (Fig.
The window Settings will be opened (Fig.
Samples per second: This should be 192000 (required sample rate).
If not, select this value from the drop down list.
Buffer: Interval width of frequency analysis. You may experiment with the
given values of buffer size.
Optimal depiction of the panorama curves is the goal.
For every new value click OK and check the result.
5c).
A1-
6b).
A1-
7).
A1-
Fig.
8
A1-
8).
A1-
6b