Table of Contents
Advertisement
PT-8000A Operating Manual v2.00.33
Displayed Memory Channel
Information
CHANNEL Operation
Bank #
Channel #
Termination of
CHANNEL Operation
Mode
After selecting the memory bank through pushing softkeys BANK 1, BANK 2
and BANK 3 the control MEM/CH / STEP-VFO gives access to 99 memory
channels by turning.
Both MAIN- and SUB-RX can read and write into the memory.
The frequency resolution of the stored value depends on the resolution of the
current frequency. It will be written to the VFO in the same manner.
Channels which are selected for SCAN operation (see chapter 16, Page 52)
are marked by an asterisk (*). If the frequency of the marked channel lies within
the SCAN boundaries it will be used for SCAN operations.
If there was no memory content written to the VFO by pushing softkey
⇨
CHAN
VFO, pushing CHANNEL again will terminate CHANNEL operation.
If the CHANNEL menu is not displayed, pushing CHANNEL will call it up and
second pushing will terminate CHANNEL operation:
The last used VFO frequency will be activated.
VFO menu will be called up.
CHANNEL LED will turn off.
Bandwidth
Stored Frequency
Fig. 42
SCAN Marker
**
** SCAN Function temporary disabled
35
Advertisement
Table of Contents
