Table of Contents
Advertisement
8
A2-
Fig.
21
A2-
Comparing Version
Numbers
Fig.
22
A2-
Fig.
23
A2-
Warning Notice
Fig.
24
A2-
Fig.
25
A2-
Does the new operation program loaded in the PC not match to the selected
CPU of the PT-8000A, this is pointed out with an error message box
(Fig.
21).
A2-
Note that the selected CPU of the PT-8000A matches to the operation
program loaded in the PCs update program (letters M, R and K are prefixed to
the version number).
Now the update program compares the version numbers of the current and
the new operation program. Depending on the outcome different messages
are shown on the PT-8000A display and PC message boxes.
In case the new operation program has a higher version
number than the current version on PT-8000A, the display will
show these numbers in the lower area.
On the PC a message box prompts you to start the program transfer.
Click OK to start the program transfer.
In case the new operation program has the same version
number as the current version on PT-8000A, the display will
show a warning notice and in the lower area these
(identical) numbers.
On the PC, a message box will show a warning notice that the new
program version number is identical to the current version.
The message box prompts you to start or abort the program transfer.
Click OK to start the program transfer.
By clicking Cancel, the program transfer will not performed.
If the update procedure should not be further
continued at this point, the PT-8000A is set back
to the normal mode by turning off (POWER) and
restart (after a wait of about 10 seconds).
Advertisement
Table of Contents
