Table of Contents
Advertisement
24
10.2 AM / FM Amplitude Modulation / Frequency Modulation
AM menu
Fig. 28
FM menu
Fig. 29
Pushing AM/FM button activates the last used mode (AM, AME USB, AME
LSB, FM, FM RPT or FM RPT+) and will call up the allocated softkey menu
(AM menu respectively FM menu). Is this e.g. one of the AM modes, pushing
AM/FM again toggles to the last activated FM mode.
Amplitude Modulation (carrier and two sidebands);
the softkey will be displayed inverse (as shown here);
the display will show
AM
AM Synchronous (AME – AM Equivalent; carrier and Upper Sideband);
the softkey will be displayed inverse;
the display will show
AME
AM Synchronous (AME – AM Equivalent; carrier and Lower Sideband);
the softkey will be displayed inverse;
the display will show
AME
Cyclic change of frequency tuning steps:
1 Hz 10 Hz 100 Hz 1 kHz
Frequency Modulation (standard mode);
the softkey will be displayed inverse (as shown here);
the display will show
FM
FM repeater mode "standard"; the transmit frequency is lower (0 ... 2 MHz)
than the receive frequency; the softkey will be displayed inverse;
the display will show
FM–
FM repeater mode "inverse"; the transmit frequency is higher (0 ... 2 MHz)
than the receive frequency; the softkey will be displayed inverse;
the display will show
FM+
Push and hold to monitor the repeater receive frequency (the softkey will be
displayed inverse); squelch is deactivated; only available if repeater mode is
selected.
Push to set the frequency shift for repeater mode (the softkey will be displayed
inverse flashing; range 0 ... 2 MHz (see next Page).
Cyclic change of frequency tuning steps:
1 Hz 10 Hz 100 Hz 1 kHz
(left of frequency).
(left of frequency).
(left of frequency).
(left of frequency).
(left of frequency).
(left of frequency).
Advertisement
Table of Contents
