Docomo SH-05A Instruction Manual page 277

If i-appli stand-by is set, the i-appli stand-by confirmation screen
appears when the handset is turned on. Select [Yes] or do nothing for
approximately 5 seconds to start i-appli stand-by. Select [No] to show
normal stand-by and cancel i-appli stand-by settings. However, when
the handset is turned on by the Auto power ON setting, the confirmation
screen does not appear and i-appli stand-by starts when the stand-by
display reappears.
i-appli stand-by is not available when the 2in1 mode is set to [Dual
mode] or [B mode].
The following operations temporarily end stand-by i-appli.
Camera
Data box
i-mode
Mail
Videophone
Data Security Service
Changing i-appli settings
Playing i-motion
ToruCa
Changing 2in1 setting (switching modes, switching ON/OFF of 2in1
function)
Displaying i-Widget screen
[Security error]
While i-appli stand-by is set, if an incorrect i-appli action is attempted,
or the use of a function not permitted is attempted, i-appli stand-by is
disabled.
If an error that cancels i-appli stand-by occurs, the error time and other
information appear and are recorded in the error history. No information
is recorded when ended properly. When [Security error] appears in
stand-by, press t to view the error history.
Sending via iC communication
Ir communication
Downloading i-appli
Starting i-appli
Manga&BookReader
PDF Viewer
1Seg
Updating software
Updating pattern definitions
Managing i-appli
Upgrade i-appli saved in the FOMA terminal and view run error
and trace information.
Some software saved on the handset may be accessed by the IP
(Information Provider) and service may be stopped directly. In such
cases, the software cannot be run, set as stand-by or upgraded. Only
deleting and viewing software details are available. To use again, the
software needs to be contacted with an activation transmission. Contact
the IP (Information Provider).
Data may be sent from the IP (Information Provider) to some software
saved on the handset.
When the IP (Information Provider) requires stop/resume of software or
sends data to software, the handset transmits data and the i-mode icon
flashes.
Upgrading
■ <Upgrade>
Upgrade software saved in the FOMA terminal if a new version is available
on the site.
1
In the software list screen, select
[Upgrade]/[Yes].
: When software description appears: Press t.
i-appli cannot be upgraded when the FOMA terminal handset does not
have enough available memory. Delete other software or data in Data
box that shares memory area with i-appli.
For some Osaifu-Keitai compatible i-appli, downloading and upgrading
may not be available while IC card lock is set.
Mail-type i-appli software that changes the mail folder name cannot be
upgraded while Function lock is applied to the Mail.
software/C/
275