Running I-Appli From Sites Or I-Mode Mail - Docomo SH-05A Instruction Manual

i-appli To
Running i-appli from sites or i-mode
mail
If i-appli To (Run i-appli) is set, i-appli can be started from a site,
i-mode mail, Message R/F, screen memo or ToruCa.
i-appli can also be started when the i-appli start signal is received in the
following methods.
Ir communication
When the b mark is held up to a scanning device
Bar code reader
Set whether to allow i-appli To in i-appli To settings (nP. 260).
Starting i-appli from sites or i-mode mail
<i-appli To>
Cannot be activated as i-appli stand-by.
Cannot be activated with Full Browser.
1
While viewing a site, mail, Message R/F, screen memo
or ToruCa, select i-appli/t/[Yes].
: To cancel: Press H while [i-appli activating] appears/[Yes].
When i-appli is ended, the original site, received mail details screen,
screen memo or ToruCa display screen reappears.
If there is no software corresponding to the Run i-appli setting, [No
requested software] appears.
Depending on the site, the specified software can be downloaded or
updated if it is not saved on the FOMA terminal or if a newer version is
available for the software saved on the FOMA terminal.
Network set (nP. 260) may be required while i-appli software is
running.
i-appli To from i-mode mail is a function only available from i-mode mail
delivered from an IP (Information Provider). Not available for i-mode
mail exchanged between FOMA terminals.
274
i-appli stand-by
Setting i-appli as stand-by display
Press c to operate i-appli set as the stand-by display. The i-appli
stand-by settings are not disabled, and the i-appli stand-by is restarted
when the stand-by display reappears.
Set whether to transmit from the software set as the i-appli stand-by,
using Stand-by network set (nP. 258).
1
In the Custom menu, select [Settings]/[Disp/LED/
Power saver]/[Set screen]/[Stand-by
[i-appli].
2
Select software/t.
: When the software using a transmission is set, a screen asking
whether to allow a transmission appears. Select [Yes] to allow a
transmission. When [No] is selected, data is not allowed to transmit
and information may not be sent.
: To set a different i-appli as stand-by: Select [Settings]/select
software/t/[Yes].
: To end the i-appli set as stand-by: Select [End].
: To disable the i-appli set as stand-by: Select [Cancel].
Only one software can be set as i-appli stand-by.
Some software cannot be set as i-appli stand-by.
If i-appli stand-by is set, i-appli appears as stand-by. The image set as
the stand-by display of Set screen does not appear. If i-appli stand-by
is disabled, the image set as the stand-by display of Set screen
appears.
Web To functions are not available from i-appli stand-by.
If software that transmits data is set as i-appli stand-by, the software
may not operate properly depending on the signal strength.
If All lock is set when in i-appli stand-by, i-appli stand-by display closes
and [待受画面1] appears.
If i-appli DX is set as i-appli stand-by, some i-appli DX software may
transmit data to verify the validity of the software regardless of the
software Network set.
display]/