Mitsubishi 3000GT Service Manual page 491

ENGINE AND EMISSION CONTROL
ON-VEHICLE SERVICE
CRUISE CONTROL CABLES CHECK AND ADJUSTMENT
Cruise control actuator
Adjusting nut B , LA;
Throttle cable
Accelerator cable --
(1) Set the air conditioning, lights and other switches to OFF
for inspection at no load.
(2) Let the engine warm up until it runs at idle.
(3) Check that the idle speed is within the specified range.
(4) Stop the engine and set the ignition switch to OFF.
(5) Check that the accelerator cable, cruise control cable
and throttle cable are routed without sharp bends.
(6) Depress the accelerator pedal to check that the throttle
lever moves smoothly from the fully-closed to fully-opened
position.
(7) Check the free travel state of the inner cables of the
accelerator cable, cruise control cable and throttle cable.
(8) If the inner cables are too loose or have no free travel
I
at all, check using the following procedure.
1) Remove the link protector.
2) Loosen the adjusting and lock nuts of the throttle
TSB Revision
Cruise control assembly
Adjusting nut A
Adjusting nut C
lever and intermediate links A, B and C to place the
throttle lever and intermediate links A, B and C in
the free state.
Link A