Mitsubishi 3000GT Service Manual page 774

4
When diagnostic trouble code Nos. 61, 62, 63 and 64 are output.
Using scan tool, check actuator. (Refer to
with diagnostic trouble code No., disconnect con-
nector directly connected to shock absorber, and
Standard: 5 V
Is continuity provided between No. 2 and 4 termi-
nals and ground?
Yes
While measuring No. 5 terminal voltage, force-
drive actuator by scan tool. Is terminal voltage
up to specification?
Standard: 9 V during forced drive of actuator
(for approx. 1 sec.) 0 V except during forced
drive
Yes
Is trouble corrected by replacing shock absorber -
(includingdamping force changeover actuator and
tic trouble code No.?
Yes
End
ECS - Troubleshooting
Is continuity provided across the following areas of shock ab-
sorber associated with diagnostic trouble code No.?
Shock absorber terminal
FL No. 1
FL No. 3
RR No. 1
RR No. 3
Yes
Check the shock absorber which corresponds to the displayed diagnosis code No.
for the continuity between terminal No. 1 and the body ground and terminal No.
3 and the body ground.
No
Replace ECS control unit.
Correct harness (between No. 2 and 4 terminals of shock absorber and ground).
No
Is continuity provided across the following areas of shock ab-
sorber associated with diagnostic trouble code No.?
N o
Yes
Check the shock absorber which corresponds to the displayed diagnosis code No.
for the continuity between terminal No. 5 and the body ground.
No
TSB
Revision
ECS control unit terminal
No. 7
No. 6
No. 10
No. 9
No. 13
No. 12
No. 16
No. 15
Correct harness.
Yes
1
Correct harness.
No
Correct harness.
Yes
1
Correct harness.