Mitsubishi 3000GT Service Manual page 816

REAR SUSPENSION cAWD>
I
Lower down the lower arm on the crossmember side. Then,
install the special tool and disconnect the lower arm ball joint
from the knuckle.
Caution
1. Be sure to tie the cord of the special tool to a nearby
part.
2. Loosen the nut but do not remove it.
INSTALLATION SERVICE POINT
NUT INSTALLATION
Holding the stabilizer link with a wrench, tighten the self-locking
nut so that the protrusion of the stabilizer link (dimension
A indicated in illustration) is within the standard value.
Standard value (A) : 5-7 mm (.197-.276 in.)
INSPECTION
Check the bushing for wear and deterioration.
l
Check the upper arm or lower arm for bend or breakage.
l
Check the ball joint dust cover for cracks.
l
l Check all bolts for condition and straightness.
BALL JOINT BREAKAWAY TORQUE CHECKING
Using the special tool, measure the ball joint breakaway
torque.
Standard value: 2-9 Nm (17-78 in.lbs.)
BALL JOINT DUST COVER REPLACEMENT
(1) Remove the dust cover.
(2) Apply multipurpose grease to the lip and inside of the
MB990800
dust cover.
(3) Drive in the dust cover with special tool until it is fully
. Dust cover
seated.
Snap ring
9
TSB Revision