Mitsubishi 3000GT Service Manual page 492

17-32
ENGINE AND EMISSION CONTROL
Adjusting nut C
Link B
Link B lever
Adjusting nut A
Link B
3) Set the ignition switch to ON (do not start the engine).
4) Rotate intermediate link C in the direction shown until
it is blocked by the stopper, turn down adjusting nut
C in the direction that the free travel of the inner
cable is reduced, and back off adjusting nut C the
specified number of turns just before intermediate
link C begins to move.
Amount adjusting nut C is to be backed off:
<M/T> About l/2 turn [inner cable free travel
O-l mm (O-.04 in.)]
About two turns [inner cable free
travel 2-3 mm (.08-.12 in.)]
5) Secure the accelerator cable with the lock nut.
6) Turn down adjusting nut B in the direction that the
free travel of the inner cable of the throttle cable
is reduced.
At the position where the lever of intermediate link
B is brought into contact with intermediate link C,
back off adjusting nut B the specified number of turns.
Amount adjusting nut B is to be backed off:
About one turn [inner cable free travel l-2
mm (.04-.08 in.)]
7) Secure the throttle cable with the lock nut.
8) Secure the adjusting bolt of the intake manifold plenum.
9) Turn down adjusting nut A in the direction that the
free travel of the inner cable of the cruise control
cable is reduced. At the position where the lever of
intermediate link A is brought into contact with inter-
mediate link B, back off adjusting nut A the specified
number of turns.
Amount adjusting nut A is to be backed off:
About one turn [inner cable free travel l-2
mm (.04-.08 in.)]
10) Secure the cruise control cable with the lock nut.
11) After adjustment, check to see that the end of the
engine speed adjusting screw is in contact with the
stopper of the throttle lever.
CRUISE CONTROL SYSTEM CHECK
CRUISE CONTROL MAIN SWITCH CHECK
(1) Turn the ignition key to ON.
(2) Check to be sure that the CRUfSE CONTROL ON indicator
light within the combination meter illuminates when the
main switch is switched ON.
I