Mitsubishi 3000GT Service Manual page 418

ENGINE COOLING - s
Air intake hose 6
INSTALLATION SERVICE POINTS
INSTALLATION
Assemble the air intake hose A with its notches (arrow-marked)
A
lined up with the marks on the air intake hoses B and
C.
Insert the hoses into the air intake hose A until they are
bottomed.
insert the air intake hose B on the turbocharger side until
they are bottomed.
INSPECTION
ENGINE COOLANT TEMPERATURE GAUGE UNIT
Refer to GROUP 54 - Meters and Gauges.
ENGINE COOLANT TEMPERATURE SENSOR (Engine
control)
Refer to GROUP 13A - MFI System Inspection.
AIR CONDITIONING ENGINE COOLANT
TEMPERATURE SWITCH cup to 1993 models>
(1) Immerse the A/C engine coolant temperature switch in
oil and then heat (by using a gas stove flame or similar
method) so as to increase the oil temperature.
(2) Check to be sure that the AK engine coolant temperature
switch is switched OFF when the oil temperature reaches
the standard value.
Standard value: 112-118°C (234-244°F)
Caution
The oil used above should be engine oil and should
be stirred well while being heated; do not heat more
than necessary.
I