Mitsubishi 3000GT Service Manual page 944

SERVICE BRAKES - G Sensor cAWD-ABS>
(3) Incline the G sensor toward the vehicle rear gradually
and check that continuity is lost at an angle of 30" or
more.
(1) Disconnect G-sensor connector and connect special tool
between terminals of the disconnected connector.
(2) With the ignition switch turned ON, read output voltage
between terminals No. 2 and No. 3.
Standard value: 2.3-2.7 V
(3) With the special tool connected, fix the connector in such
a manner as to direct the front mark on the G-sensor
mounting surface downward and read output voltage
between terminals No. 2 and No. 3.
Standard value: 3.3-3.7 V
(4) If the output deviates from the standard value, make sure
that nothing is wrong with the power supply wire and
ground wire and then replace G-sensor.
1
TSB Revision