Mitsubishi 3000GT Service Manual page 812

REAR SUSPENSION <AWD> - Rear Suspension Assembly
REMOVAL AND INSTALLATION
Pre-removal Operation
Rear Side Trim Absorber
l
to GROUP 52A - Trims.)
(Refer
Post-installation Operation
Center Exhaust Pipe and Main Muffler Installation
l
(Refer to GROUP 15 - Exhaust Pipe and Main Muffler.)
Rear Side Trim Absorber Lid Installation
l
(Refer to GROUP 52A - Trims.)
Power Steering System Refilling and Bleeding
l
(Refer to GROUP 37A - On-vehicle Service.)
30-35 Nm
Removal steps
1. Shock absorber mounting nuts
2. ECS connector cECS>*
3.
Cap*
4. Brake tube to brake hose connection*
(Refer to GROUP 35 - Brake Line.)
5. Brake caliper*
6. Brake disc*
7. Parking brake cable end*
(Refer to GROUP 36 - Parking Brake.)
8. Pressure tube assembly to pipe
assembly connection <4WS>
9. Feed pipe assembly to suction hose
connection <4WS>
10. Return pipe assembly to rubber hose
connection c4WS>
Lid Removal
45 Nm
1
3 ft.lbs.
3
12 36-43 ft.lbs.
80-94 ft.lbs. )bx
Center Exhaust Pipe and Main Muffler Removal (Refer
l
to GROUP 15 - Exhaust Pipe and Main Muffler.)
Wheel Alignment Checking (Refer to P.34-25.)
l
4WS System Bleeding and Operation Inspection
l
(Refer to GROUP 378 - On-vehicle Service.)
Parking Brake Lever Stroke Checking
l
(Refer to GROUP 36 - On-vehicle Service.)
2
4
11. Power cylinder tie rod coupling nut
12. Differential carrier to propeller shaft
coupling bolt and nut
13. Center bearing mounting nut
14. Harness connector CABS>*
15. Parking brake cable and ABS sensor
fixing bolt CABS>*
16. Cable band*
17. Crossmember bracket*
18. Crossmember mounting nut (on
differential side)*
19. Rear suspension assembly
NOTE
Parts marked with * are symmetrical.
I