Mitsubishi 3000GT Service Manual page 678

MB990932
MB991355
or MB991 056
I I
MB990947
MB990998
Turn the nut
FRONT AXLE
(2) Remove the wheel bearing inner race from the hub by
using the special tool:
Caution
Be careful that the hub will not fall down as the wheel
bearing inner race (outer side) is removed from the
hub.
(3) Remove the snap ring from the knuckle.
(4) Remove the bearing by using the special tools.
NOTE
Removal is easier if the outer side inner race removed
from the hub is placed on the bearing and the wheel
bearing is then removed.
REASSEMBLY SERVICE POINTS
(1) Fill the wheel bearing with multipurpose grease.
(2) Apply a thin coating of multipurpose grease to the knuckle
and bearing contact surfaces.
(3) With the wheel bearing inner race removed, press-in the
bearing by using the special tools.
(4) Install the wheel bearing inner race to the wheel bearing.
(1) Drive the oil seal (hub side) into the knuckle by using
the special tools until it is flush with the knuckle end
surface.
(2) Apply multipurpose grease to the lip of the oil seal and
to the surfaces of the oil seal which contact the hub.
ADJUSTMENT
(1) Use the special tool to mount the hub assembly onto
the knuckle.
(2) Tighten ,the nut of the special tool to 200-260 Nm
(3) Rotate the hub assembly in order to seat the bearing.
7
TSB Revision