REMOVAL AND INSTALLATION
Removal steps
1. Stabilizer bracket mountina bolt
3. Bushing
5. Joint cup (A)
6. Stabilizer rubber
REAR SUSPENSION cFWD>
INSTALLATION SERVICE POINTS
Hold
with
wrench
(1) Hold the stabilizer link ball studs with a wrench and install
the self-locking nut (A).
(2) Holding the stabilizer link with a wrench, tighten the
self-locking nut (B) so that the protrusion of the stabilizer
link is within the standard value.
Standard value: 5-7 mm (.197-.276 in.)
TSB Revision
7. Joint
10. Joint cup (A)
11. Stabilizer rubber
12. Stabilizer bar
SELF-LOCKING NUT INSTALLATION
CUD