Mitsubishi 3000GT Service Manual page 718

Mating marks
MB990831 ----+
MB990847 '
Differential support member
Differential
REAR AXLE cAWD>
REMOVAL SERVICE POINTS
With atire lever, etc., remove the drive shaft from the differential
carrier.
NOTE
Be cautious to ensure that the differential carrier oil seal is
not damaged by the drive shaft spline.
(1) Make mating marks on the differential companion flange
and the propeller shaft flange yoke for reference during
reassembly.
(2) Remove the differential carrier and propeller shaft
connection.
(3) Support the propeller shaft with wire.
Holding the bottom of the differential carrier and removing
the rear wheel oil pump through the mounting hole, remove
the differential carrier.
Caution
1. Use care not to damage the rear wheel oil pump gears.
2. Use care not to allow dirt or foreign matter to fall
into the differential carrier.
DIFFERENTIAL SUPPORT BUSHING AND
DIFFERENTIAL SUPPORT MEMBER BUSHING
REPLACEMENT
Install or remove the bushing using the special tool. Install
the bushing with its hollow portion facing in the direction shown.
Caution
Install the bushing with the differential support and differ-
ential support member chamfered end first and install
until the bushing outer case end face is flush with the
support and support member.
0 0 0 0 1 0 4 9
evision
TSB
I