Mitsubishi 3000GT Service Manual page 682

FRONT AXLE -
Drive Shaft
INSTALLATION SERVICE POINT
(1) Be sure to install the washer and wheel bearing nut in
the specified direction.
(2) After installing the wheel, lower the vehicle to the ground
and finally tighten the wheel bearing nut.
(3) If the position of the cotter pin holes does not match,
tighten the nut up to 260 Nm (188 ftlbs.) in maximum.
(4) Install the cotter pin in the first matching holes and bend
it securely.
INSPECTION
Check the drive shaft boot for damage or deterioration.
l
Check the ball joints for wear or operating condition.
l
Check the spline part for wear or damage.
l