Mitsubishi 3000GT Service Manual page 631

&t& pressure (h)Torque
converter
pressure
I
STANDARD HYDRAULIC PRESSURE TABLE
NOTE
(1) -: Indicates pressure is below 10 kPa (1.4 psi).
(2) SW-ON: OD switch in ON position.
(3) SW-OFF:
OD switch in OFF position.
(4) *: Pressure is not standard.
AUTOMATIC TRANSAXLE
HYDRAULIC PRESSURE TESTS
1. Completely warm up the transaxle.
Raise the vehicle by using a jack so that the front wheels
2.
can be rotated.
3. Connect an engine tachometer and place it in a position
where it's easy to see.
4. Attach the special oil-pressure gauge (MD998330 or
I
pressure-
MD999563) and the adaptor (MD998332) to each oil-pres-
I
sure outlet port.
When the reverse position pressure is to be tested, the
3,000 kPa (400 psi) type of gauge should be used.
5. Measure the hydraulic pressure under various conditions,
and check to be sure that the measured results are within
the standard value range shown in the "Standard oil pres-
sure table" below.
If the oil pressure is not within the specified range, check
and repair as described in the section "Remedial action
to take for inadequate hydraulic pressure" on the next